Large Diameter Steel Ring Gear

Large diameter ring gear Feature,
1. Material: Stainless steel steel alloy steel and brass etc
2. Processing: Forged, casting, heattreatment, or quenching and tempering carburization
3. Quality: Finest material and process.
4. Can design and manufacture gear wheel and sprocket wheel.

Application:
The products can be widely used in the area of cement mill, rotary kiln, shipbuilding,
Metallurgy, mine, sugar mill, powder plant, rail road, engine bed and so on.

We can provide OEM service for cement mill and rotary kiln casting parts, marine steel casting parts, sugar mill machinery parts with carbon steel or low alloy steel.
The casting parts can be supplied as following treatment:
Heat Treatment: Normalized, normalized and tempered, quench and tempered
Machining: Rough machined, semi-finished machined, finished machined

Quality warranty and testing equipment:
Magnetic powder inspection
UT nondestructive test
Dye inspection
Leeb hardness testing equipment
Machinery performance testing equipment
Metallographic microscope
Direct-reading spectrometer

Features of our products:
Durable
Excellent tensile strength
Accurate level of tolerance
Resistance to corrosion
Resistance to extreme temperature conditions
Good dimensional accuracy
Superb surface finishing
Easy to use and install
Possible defects:
Defect
Causes
Unfilled sections
Insufficient material
Low pouring temperature
Porosity
Melt temperature is too high
Non-uniform cooling rate
Sand has low permeability
Hot tearing
Non-uniform cooling rate
Surface projections
Erosion of sand mold interior
A crack in the sand mold
Mold halves shift
There are no these problems for us.
Uniform wall thickness will ensure uniform cooling and reduce defects. A thick section, often referred to as a hot spot, causes uneven cooling and can result in shrinkage, porosity, or cracking.

Corners
Round corners to reduce stress concentrations and fracture
Inner radius should be at least the thickness of the walls

Machining allowance
Add 0.0625 - 0.25 in. (0.16 - 0.64 mm) to part dimensions to allow for machining to obtain a smooth surface.